Search:

Here's my table. 516 My address is the same as on file. Let me know if you want me to email it to you.

Everyone's tables are so clean compared to mine. I feel like a bad owner!

Got it figured out. Turned out to be one of the wires on the A axis was lose, so I backed off the connector screw, pushed the wire in and screwed it back down making a good connection. The table...

http://youtu.be/xgR1wB88sVU

This is a quick video of what the gantry is doing.

Today it got pretty cold going from 70s to the 30s so wondering if it loosened up a bit.

All three studs have washers and the washers are on the outside of the motor gear units. The two outside...

Does anyone have the procedure for adjusting the gear reduction motor drive units on the side of the gantry for the Y axis?

My Y axis is extra loud lately and I noticed that in one direction the...