Ford Priming tool on ebay?

[FrankNB]

I was shopping for a cheaper tool, just cause US exchange kills my wallet converted in Canadian funds.. anybody know if this could be used on AMC engines...

http://cgi.ebay.com/ebaymotors/ws/eB...tem=2485174105

[jeepsr4ever]

basically if your going to use that you may as well use a screwdriver end. If it doesnt fit the timing cover or stay on the oil pump drive gear shaft it will cause problems.

[FrankNB]

I knew you were going to say that.. now, I have no other option but to get the one you make.. I'll wait a few weeks, till I have fully absorbed the cost of the timing cover.. It shouldn't be much for shipping, I figure that thing is pretty light...

[jeepsr4ever]

I will not push my goods generally, but i can tell you that sometimes priming that pump can be tricky, ive done about everything wrong i could priming that sum gun. broken screwdrivers, smoked drills, gouged pumps, ran them backwards before...everything... thats why i invented the tools, it isnt really a new idea either

[tufcj]

I made my own out of a junkyard distributor. I removed the distributor gear, cut the housing just above the hold down boss, and cut the shaft just below the mechanical advance weights. Ground 3 flats in a triangle on the shaft so the drill chuck wouldn't slip. I used it today. My new 390 came up to about 70 PSI using a very low speed 1/2" drill. Get to drop it in this weekend.