Well I pulled my gauge cluster out and the people that had my 1975 Wagoneer before me did a bang up job screwing it up. All pins have been broken off and there are some burn spots on the board. A very smart person would throw it out a head to Pick & Pull. But not me I’m going to save this poor thing. Or at least give it a good try. Can any one tell me the min. gauge wire I have to use? I have a piece of 18- 20 gauge ribbon wire that has 10 wires in it but that might be too small. Or I’ll just use 14 and label each wire because I only have red & black.