Solid Roller Lifter Rev Kit

[AMX69PHATTY]

If I could just make some more money ..........

[milnersXcoupe]

Tech Tips - [quote]

AMC V-8 Rollers:

When installing a roller cam and lifters in an AMC V-8, make sure you pay attention to your lifters and their bores.

You want to make sure that your oil relief band (on the lifter) is not coming out of the bore.

This in not common, but it does happen due to a core shift when the block is made.

If the relief band is coming out of the bore, you will lose oil pressure to the top of your engine.

The fix for this is to change the base circle size on the cam, thus reducing the height at which your lifter sits!

This will allow the oil to stay in the lifter gallery and travel through the lifter, instead of lying in the valley of the block.

[end CRANE CAMS quote]

[Jungle Jim]

[quote="mad max"]ok, estimate on making billet spring plates patterned from the cast crane ones is 180-200 for a pair, if we can get several sets pre sold.
thats just the spring plates.
if we could get several commitments for them that would be nice.
it will cost quite a bit to make the jig and do the program just to do 1 or 2.
shoot me e mails if your are serious about these.

we are currently working on a 2 piece amc valve cover also.
let me know if anyone hads interest in these as well.

thanx rick wyman



Rick You say you are working on a 2-piece valve cover....made from??? Any pics of prototype or ???

Jim

[jeepsr4ever]

I saw it at Cordova! Nice large 2 piece valve cover. I think I may have a pic or two. I will scout around

[xracer390]

I saw it at Cordova! Nice large 2 piece valve cover. I think I may have a pic or two. I will scout around

Show me the Pics !