AMC 360 Bare Block Fresh Bore @ .030

[happyhoppy]

Have an AMC 360 block at the NAPA Machine shop that has been tanked, magnafluxed and bored .030 over. Bad news - when I had a pile of scrap to be picked up the main caps were taken by mistake.

I do have another set from another engine and they are at the machine shop so line hone/bore can be checked.

It's been at the shop for a long time and I must get it out. Building an AMC 401 and I'd like to sell this.

Have $175.00 invested in this and I'd like to get that out of it.
Bath, NY 14810 - Can meet someone up to 100 miles with this early on a weekend.
If pictures are needed I can email.
hoppym38@yahoo.com

[jeepsr4ever]

I have had this happen to me a couple times. Not really a big deal to install any caps from any AMC V8 and its always a good idea to get them honed. $175 is a good price for all that work!

[happyhoppy]

$175.00 was just for the boring, etc. Line hone or bore hasn't been done - quote of $250.00 to line bore. Rather put that into my 401.