Quote Originally Posted by grignac48
Working on the body for my CJ7. I replaced the corners and they came out good!. Now I am moving to the side panels and the seatbelt and rollbar areas. Anybody have pics of what they did in that area. I am concerned that the roll bar bolts are smaller than the seatbelt bolts. I was going to replace the seatbelt mounting and build it up. I also looked at the frame tie in kits for the roll bar. Looking for ideas and such.

Thanks
Well if I remember right the roll bars and seatbelts are both 3/8's grade 8. When I rebuilt my B-pillers (85 CJ), I had the skin off the outside and welded in 7/16 nuts after fixing the pillar its self. Then I welded in the new sheet metal panels.

After doing all that, I too went with a 4-point harness, but still have the stock belts just in case VDOT doesn't think the 4-point is safe (wouldn't surprise me)