Well Im out. My wife changed it all up on me. Shes flying to KY by herself this weekend. So I hope you sell them to someone who cares
Well Im out. My wife changed it all up on me. Shes flying to KY by herself this weekend. So I hope you sell them to someone who cares
Just Empty Every Pocket
www.dirteaters4x4.com
I took a piece of 2.5 ID/3.0 OD .250 thick tube, split it long ways, leaving a small gap, and wrapped it around my AMC 20 tubes. Clamped the tube around the 20, welded the seams and 20 tube together with my mig. Used nickel rod and arc welder to attach tube to center section. You can also put a couple of rosset welds in there. Ground down the welds, and you can't even tell anything was done. Use new spring perches for 3 inch axle tubes. I am running a detroit locker with full floating kit and rear disc brakes, pretty hot 401. No problems with the rear axle or flex.Originally Posted by 76-cj7
Hmmm....thats a good idea you got....i always thought of doing something along them lines but never went all the way with it
1980 CJ-5, 360 powered, T-18, Dana 20, Advanced Adapters output , 4.56's, Dana 30 frt chromoly shafts w/297 joints and Tru-Trac and M20 rear with Detroit, Superior shafts, and disc brakes and Tom Woods frt and rear shafts.........about 10k in misc aftermarket parts!
KYOriginally Posted by crabshaver
" “It is said that men go mad in herds, and only come to their senses slowly, and one by one.." -Charles MacKay
"'The trouble with our liberal friends is not that they're ignorant; it's just that they know so much that isn't so.' "
-Ronald Reagan
VOTE
Hey is that the new grease?Originally Posted by Mudrat
Just Empty Every Pocket
www.dirteaters4x4.com
Not new, been around for decades, but it IS water soluble
" “It is said that men go mad in herds, and only come to their senses slowly, and one by one.." -Charles MacKay
"'The trouble with our liberal friends is not that they're ignorant; it's just that they know so much that isn't so.' "
-Ronald Reagan
VOTE