Looking for REALLY CHEAP or FREE STUFF for AMC 360

[fifesjeep]

As the subject say I am looking for REALLY CHEAP or FREE STUFF for the AMC 360...
If anybody has any junk that they want to get rid of for Cheap or better yet FREE Let me know. I'm looking to do a basic small budget build to maximize HP/Torque per dollar spent...

Things I need or would like:

A Good Used Edelbrock intake....

A Good in working condition Carb Holley or Edelbrock 650-750 cfm...

A set of Good Used 1.6:1 Roller Rockers....

If anybody has a cam/lifter set sitting in their garage/shop collecting dust I'm Looking for either an RV cam or something equivalent to a Comp Cams 270... or there abouts.

And where do I find the AMC Blue paint for the Engine Block/Heads?

Thanks.

[dwloop]

Eastwood sells the AMC Blue engine paint...

Dave

[fifesjeep]

Thanks man!

[PavementPounder]

I have an extra Holley or two that are at least 600's, I think. I'll get a picture.

[fifesjeep]

Awesome... are they in working condition or would they need a rebuild?

[PavementPounder]

Awesome... are they in working condition or would they need a rebuild?

No idea. Never used them.

[Mudrat]

Rich, I have a cam and lifters. Not sure the grind, I'll need to look a the spec sheet again.

Come see me when I get back.

[fifesjeep]

Pat,

Just give me a shout when you get back... I'm finally going to pick up the Keenserts from MSC... and then this weekend your knuckle should be good as new... Do you want me to hold on to the knuckle until you get back or drop it off?

Rich

[Mudrat]

Just hang onto it unless you head back up my way for some reason. No need for an extra trip. Did the Kensert place have 4" studs?

Just don't confuse it with the stuff your selling

Pat,

Just give me a shout when you get back... I'm finally going to pick up the Keenserts from MSC... and then this weekend your knuckle should be good as new... Do you want me to hold on to the knuckle until you get back or drop it off?

Rich

[fifesjeep]

Just hang onto it unless you head back up my way for some reason. No need for an extra trip.

Will do...

Did the Kensert place have 4" studs?

Not that i have found yet...

I'm looking at GM part numbers... (I'm not sure if this is the correct P/N 3965137... I can't find the length/threads for these).
ARP I know has them it's only a matter of finding them in their catalog...

Just don't confuse it with the stuff your selling

No worries there... your knuckle is pretty... the only one that look remotely similar to yours is the D60 knuckle and it's kinda hard to confuse the two... lol.