went to test fit distributor in engine after rebuild bottom of distributor housing is hitting the cam gear
stock distibutor w/ mallory unlite conversion
plated timing cover from bulltear
new cam and distributor gears
went to test fit distributor in engine after rebuild bottom of distributor housing is hitting the cam gear
stock distibutor w/ mallory unlite conversion
plated timing cover from bulltear
new cam and distributor gears
My 2 thoughts are do you have the cover alignment dowels in the block, and do you have a gasket under the dizzy base?
How much contact is there?
Bob
tufcj
1969 AMX
1967 Rambler Rogue
If you need a tool and don't buy it...
you'll eventually pay for it...
and not have it.
Henry Ford
Dowels in place no gasket about .150
So the distributor is sitting down too far?
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
Try an "O" ring for a gasket. Don't over tighten.
In America, there is no natural, moral, or legal right, to obligate another person or persons, to your dept or desires.