Sorry I forgot to update the thread!! The settings solved the issue for the most part but I did tighten the ecentrics on the head as well and everything is good now. I am still getting a cut edge angularity on 1/4 inch plate but I will get it fine tuned.
I have read numerous amounts of information from Jim Colt on getting the best possible cut edge.
The Hypertherm 45 is kicking some butt!! I burned through a entire 4x4 sheet of 1/4 plate yesterday and am loving this setup!
I am looking for a program that I can scan in a template and cut from that. I am not sure that is possible but it would help me alot since I have a friend that owns a 4wd shop and has tons of templates that he has made to cut with atorch and now he wants me to cut stuff for him.
Also how do you save the material in sheetcam so that you can open it back up later and know where everything was already cut out of that sheet.

Thanks guys for the help getting this thing up and running.
Nick