Bulltear Ad
Results 1 to 3 of 3

Thread: Front cover identification

  1. 10-25-2010, 08:21 AM #1
    bcsideshow
    bcsideshow is offline
    Join Date
    Apr 2005
    Location
    Kenosha
    Posts
    8

    Front cover identification

    I am sure this has already been brought up and beat to death but I haven't found it...

    I picked up a 70 390 and I am trying to figure out what front cover is on it. It's just getting broke in (75 miles or so) and I am not having any problems but concerned. Any way to tell if it is factory, crown, Bulltear (hopefully). If crown how to identify good or bad or if it is working it is good?

    THanks
    Reply With Quote Reply With Quote
  2. 10-25-2010, 08:47 AM #2
    ironman_gq
    ironman_gq is offline
    Thank you from BT Tech Master Bulltear Forum
    Join Date
    Nov 2005
    Location
    Middle of the Iron Range MN
    Posts
    1,229
    I would think as long as everything lined up well (dizzy dropped in and is at the right height and gears arent eating the adapter plate) and if your pressure is good I wouldnt worry about it.
    Reply With Quote Reply With Quote
  3. 10-25-2010, 09:25 AM #3
    bcsideshow
    bcsideshow is offline
    Join Date
    Apr 2005
    Location
    Kenosha
    Posts
    8
    Distibutor dropped in and have correct end play. Gear looks ok. In process of installing oil pressure gaue so I will keep an eye on it. I think as funds become availabel I will go with the Bulltear ultimate setup. THanks!
    Reply With Quote Reply With Quote

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Bulltear Ad