Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958
Definition of Acceleration
Results 1 to 5 of 5

Thread: Definition of Acceleration

  1. #1
    Thank you from BT ULTIMUS MAXIMUS STATUS
    Join Date
    Feb 2003
    Location
    Back in VA for a while....
    Posts
    5,822

    Talking Definition of Acceleration

    Got this in an e-mail:

    Read this through slowly and try to comprehend the amount of force produced in just under 4 seconds!

    There are no rockets or airplanes built by any government in the world that can accelerate from a standing start as fast as a Top Fuel Dragster or Funny Car!


    DEFINITION OF ACCELERATION

    One top fuel dragster, 500 cubic inch, Hemi engine, makes more horsepower than the first 4 rows of stock cars at the Daytona 500.

    It takes just 15/100ths of a second for all 6,000+ horsepower of an NHRA Top Fuel dragster engine to reach the rear wheels.

    Under full throttle, a dragster engine consumes 1-1/2 gallons of nitro methane per second; a fully loaded 747 consumes jet fuel at the same rate with 25% less energy being produced.

    A stock Dodge Hemi V8 engine cannot produce enough power to drive the dragster's supercharger.

    With 3,000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into a near-solid form before ignition.

    Cylinders run on the verge of hydraulic lock at full throttle.

    At the stoichiometric (stoichiometry: methodology and technology by which quantities of reactants and products in chemical reactions are determined) 1.7:1 air/fuel mixture of nitro methane, the flame front temperature measures 7,050 deg F.

    Nitro methane burns yellow... The spectacular white flame seen above the stacks at night is raw burning hydrogen, dissociated from atmospheric water vapor by the searing exhaust gases.

    Dual magnetos supply 44 amps to each spark plug. This is the output of an arc welder in each cylinder.

    Spark plug electrodes are totally consumed during a pass. After halfway, the engine is dieseling from compression, plus the glow of exhaust valves at 1,400 deg F. The engine can only be shut down by cutting the fuel flow.

    If spark momentarily fails early in the run, unburned nitro builds up in the affected cylinders and then explodes with sufficient force to blow cylinder heads off the block in pieces or split the block in half.

    In order to exceed 300 mph in 4.5 seconds, dragsters must accelerate an average of over 4G's. In order to reach 200 mph (well before half-track), the launch acceleration approaches 8G's.

    Dragsters reach over 300 miles per hour before you have completed reading this sentence.

    Top fuel engines turn approximately 540 revolutions from light to light! Including the burnout, the engine must only survive 900 revolutions under load.

    The redline is actually quite high at 9,500 rpm.

    Assuming all the equipment is paid off, the crew worked for free, and for once NOTHING BLOWS UP, each run costs an estimate $1,000.00 per second.

    The current top fuel dragster elapsed time record is 4.428 seconds for the quarter mile (11/12/06, Tony Schumacher, at Pomona , CA ). The top speed record is 336.15 mph as measured over the last 66' of the run (05/25/05 Tony Schumacher, at Hebron , OH ).

    Putting all of this into perspective:

    You are driving the average $140,000 Lingenfelter 'twin-turbo' powered Corvette Z06. Over a mile up the road, a top fuel dragster is staged and ready to launch down a quarter mile strip as you pass. You have the advantage of a flying start. You run the 'Vette hard up through the gears and blast across the starting line and pass the dragster at an honest 200 mph. The 'tree' (dragstrip start line) goes green for both of you at that moment.

    The dragster launches and starts after you. You keep your foot down hard, but you hear an incredibly brutal whine that sears your eardrums and within 3 seconds, the dragster catches and passes you. He beats you to the finish line, a quarter mile away from where you just passed him.

    Think about it, from a standing start, the dragster had spotted you 200 mph and not only caught, but nearly blasted you off the road when he passed you within a mere 1,320 foot long race course.

    ...... and that my friend, is ACCELERATION!
    " “It is said that men go mad in herds, and only come to their senses slowly, and one by one.." -Charles MacKay
    "'The trouble with our liberal friends is not that they're ignorant; it's just that they know so much that isn't so.' "
    -Ronald Reagan

    VOTE

  2. #2
    Thank you from BT ULTIMUS MAXIMUS STATUS
    Join Date
    Jan 2004
    Location
    apple valley ca
    Posts
    3,435
    sucks to be the vette driver. i think the F/A- 18 jockeys would love to have a go at it
    83 eagle (r.i.p.)
    85 gl1200 gold wing LTD pilot
    1999 gl1500C valkyrie(plain gold wing)
    1994 jeep grand cherokee limited pilot
    McDonnell Douglas c-17 mechanic
    corrupting people since 1962

  3. #3
    Thank you from BT Senior Wrench of the forum Old Rugged Crosser's Avatar
    Join Date
    Apr 2010
    Location
    Bothell Washington
    Posts
    228
    [QUOTE


    Top fuel engines turn approximately 540 revolutions from light to light! Including the burnout, the engine must only survive 900 revolutions under load.

    [/QUOTE]

    Can that be correct that they only turn 540 r's . Seems like something is off. Don't they have a ton of clutch slippage and also tire slippage to account for?
    Last edited by Old Rugged Crosser; 12-21-2010 at 09:04 PM.
    Larry The Old Rugged Crosser
    in a Old Rugged Cross'en 72 CJ-5
    ------------------------------------------
    You are invited to view my rebuild of The Old Rugged Crosser --CJ-5 at:

    http://www.jeepforum.com/forum/f8/rebuilding-old-rugged-crosser-cj5-1180801/

    ------------------------------------------
    "He that is kind is free, though he is a slave; he that is evil is a slave, though he be a king." - St. Augustine

  4. #4
    Thank you from BT Tech Master Bulltear Forum
    Join Date
    Nov 2005
    Location
    Middle of the Iron Range MN
    Posts
    1,229
    figure with a redline of 9500rpm's and a run time of 4.5 seconds to get down the track the engine only turns about 700 revs if it ran at 9500 rpm the whole time. So if you work in an average rpm of 7200rpm's during the run then the engine only goes around 540 times in a 4.5 second run. Math goes like this (avg rpm's/60*time it takes to get down the track= revs per run)

  5. #5
    Thank you from BT Tech Master Bulltear Forum
    Join Date
    Jan 2003
    Location
    In a Half Dark world now a days
    Posts
    1,437
    the best is the launch

    best ever 11.669 @ 112.33 mph in 1/4 mile on 33 x 10.50 slicks and 4" lift / 7.358 @ 93.03 mph in the 1/8 mile

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Bulltear Ad