What is suggested for exhaust bolts on an early 70's 72-73 360. The ones I had before were pretty hard to get on and rusted pretty bad, not to mention came loose. Also, what is the correct size bolt for this motor?
What is suggested for exhaust bolts on an early 70's 72-73 360. The ones I had before were pretty hard to get on and rusted pretty bad, not to mention came loose. Also, what is the correct size bolt for this motor?
hello (crikets)
I've just used standard 3/8" grade 8 bolts with lock washers. Later heads used smaller bolts (5/16" ?) on the ends. I think length would be 1 3/4" as long as you use a washer, that length might bottom without one. I usually run a bottoming tap down the thread holes before running new bolts in.
Bob
tufcj
1969 AMX
1967 Rambler Rogue
If you need a tool and don't buy it...
you'll eventually pay for it...
and not have it.
Henry Ford
My '73 304 were all 3/8" and the '78 & '85 360 had (2) 3/8 and (2) 5/16 per side. All these had a hole drilled ~1" in the center of the bolt and I can't remember for the life of me what this was for.
Looking through the OMIX catalog, I did not find a listing for these bolts.
Its a Jeep Thing --- No one understands!
"America will never be destroyed from the outside. If we falter and lose our freedoms, it will be because we destroyed ourselves."
-Abraham Lincoln
Posting Permissions
Reply With Quote