AMC 360 Distributor

[rollbar]

I'm looking for a AMC distributor that fits a 360V8. Really looking for the guts so I can use it to prime the motor w/oil before start up.

Thanks,
Jim

P.S. I think my engine is a '74.

[tufcj]

I might have a points type dizzy in the parts bin somewhere. Let me check. If I have one that doesn't have any special application by the part number, I'd let you have it for the cost of shipping.

Bob
tufcj

[rollbar]

Thanks Bob, I'm sure it will work. Not really sure of the yr but I got the info off the head number so I think it is a '74.

http://www3.sympatico.ca/david.crooks/amc.PDF

II (75 & there are the letters HN stamped below it), II (24-8 or 8-24
depends how U look @ it, it's upside down on the block), II (3220502-2 &
below it there is a letter "G" stamped on the head).


So we have a rocker II(75) (HN) II(8-24) II (3220502-2) (G).

P.S. Shipping to 89407

[msalaba]

I used the shaft from a Chebby HEI Dist. for priming the oil pump on my 78 360. Worked good w/ a cordless drill. Saved the rare-ish AMC parts!

[rollbar]

Well, if you still have it, ship it, and when I get to that point I'll use it, and, ship it back.

What ever works guys is fine with me & I appreciate the help/suggestions.

[tufcj]

I have a primer already made from a dizzy. If you want to use that and ship it back, that would be fine too. I could probably fit it in a 4.95 flat rate box.

Bob
tufcj

[rollbar]

Whatever works for you Bob. I won't be ready for it until the middle/end of February hopefully. But in any case, when I'm done I will send it back if you are in no hurry.

Thanks,
Jim

[tufcj]

PM me your snail mail, and I'll send it to you. I won't need it for a while. I should get my 67 Rogue some time in March. Got a lot of work to do before the engine even goes together (69 390). Gonna make it a SC/Rambler clone, but going to use suspension from www.freakride.com. This baby is going to go straight AND turn.

Bob
tufcj

[rollbar]

PM sent, thanks again Bob.

P.S. Make sure you post pics of the build.