Results 1 to 2 of 2

Thread: CJ Windshield Wiper Motor

  1. #1
    Thank you from BT Tech Master Bulltear Forum
    Join Date
    Sep 2003
    Location
    Florida
    Posts
    1,155

    CJ Windshield Wiper Motor

    I cleaned the electrical connections where the wiper motor plugs in and it worked.

    So I decided to take it back off and bead blast the VIN plate and repaint it along w/the windshield frame behind the plate.

    No I re-install the motor w/1/4x20 Stainless Steel bolts and I tried the motor and it doesn't work.

    Fuse good.

    Wondering if the motor uses the windshield frame as a ground, or, does it have it's own.

    Thanks,
    Jim
    84' CJ8-360-Project M170 Jeep
    86' CJ7-258-Mommas Jeep
    Project CJ8 to M170 Conversion<----Click

  2. #2
    Thank you from BT Tech Master Bulltear Forum
    Join Date
    Sep 2003
    Location
    Florida
    Posts
    1,155
    Figured it out, never mind. Long Day!

    I do have grounds running to the dash (grab handle) and I found a short piece of wire and touched the new SS bolt to the dash SS bolt and it worked.

    I should have thought of that but you know how it goes.

    Thanks again,
    Jim
    84' CJ8-360-Project M170 Jeep
    86' CJ7-258-Mommas Jeep
    Project CJ8 to M170 Conversion<----Click

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Bulltear Ad