Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2968 5x10 Gantry Build - Page 2
I have went through all the cables, and connections. Even tried some new cables. I have full movement and control over the table. The power lights are on. I am getting a series of lights when I put it in test mode.....UP and ARC ON flash three times, then it switches to DOWN and ARC ON for three times and repeats. I feel like it is a communication issue and have checked out the serial/parallel port settings and compared them to the Mach manual. I thought it could be a software/driver issue too.....
Go over the limit switch section to make sure you limit switch setting isnt causing a conflict. When triggered the limit and X home or X limit should only light up
Not a laptop
Uninstalled and Reinstalled the Parallel and Serial ports
Ports configured correctly
Limit switches not the problem and disabled.
Removed and Installed Software again with out PWM hooked up.
What am a I looking for after I disconnect the PWM?