I took my jeep out for a spin for a final cruise last night before I started my engine swap to put my 401 in place of the dying 360.
It pulled out of the parking lot fine but when I pulled up to a stop light it didnt want to take off. I eased into a gas station and noticed it was a quart low but I didnt think that would make that much of a difference. It was rebuilt only 6,000 miles ago because it was sunk in a pond ( long story)...

I dont think the throttle linkage is adjusted properly because the tranny shifts fine at low speed but doesnt kick down when I give it WOT at speed or hold gears when accelerating.

Im in Colorado Springs, is this normal for cold weather or should I put some additive in and change the filter?

I have also read about adjusting the bands but I wouldnt know what I am doing there because I dont know transmissions very well.

If my knocking 360 will make it slip my new 401 with 450ft/lbs tq sure wont be help much either.

Any help is greatly appreciated.