Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2968
Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958
Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958
Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958
Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958
Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958 4x8 Gantry Build...
Helpfull BT forum member
Junior wrench of the Forum
Join Date
Sep 2012
Location
Coarsegold, CA
Posts
86
OK, we actually got our card tonight. I moved the computer out to the garage and started following CandCNC's instructions for Mach3. I have the motors plugged in and they are all locked. I tuned the motors using the parameters you (Matt) sent me in pm.
The program will not come out of reset. I am getting the "External E-stop Request" error. Possible solutions include the EPO jumper is not in place... but it IS. OR the Table I/O card is not connected... but it is, through the grey flat cable.
Any ideas?
BTW it's a real pain the ass that there arent 2 crimp spade terminals included with my gantry kit. I dont have those little connectors at home to connect the limit switches on the z axis, so yet another delay until tomorrow when I can get some. Doing this at 8 pm on a weekday to try to get this table going and... That's just ridiculous.