Lost Power to Stepper Motors

[stillworkin]

Machine was working great until friday, after i loaded my material onto the table the power from the box to the motors shut off. The red led next to the OFF button still stayed lit, and i am able to turn power to the box on and off but when i press the on button nothing happens. Also, once i flip the switch to turn power onto the box i notice that the bottom fan doesnt come on. I don't know if it is supposed to or not but just an observation. I took the front cover to the box off and found a small blue jumper sitting in the bottom of the box. I assume when i loaded the metal it vibrated off. Does anyone have a diagram i can look at to compare and find where the jumper goes?

Thanks,
Martin Fountain

[jeepsr4ever]

There are jumpers all over in the control box. Did you try pressing in the circuit braker on the side?

[stillworkin]

My breaker is on the bottom but yes I tried pushing it but it wasntt triped

[jeepsr4ever]

Do you get any blinking lights? PM sent

[stillworkin]

When i first flip the switch on the red led @ the off button comes on and then the Z and X led lights flash red once. After that i have nothing.