Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: cam bearings

  1. #21
    Helpfull BT forum member Swabie
    Join Date
    Jan 2013
    Location
    NorCal
    Posts
    49
    After looking at it further, there is no way to center bearing hole directly over slot. If you look at the slot in block, it's offset toward the back and not centered.

  2. #22
    Bulltear forum member New to the forum
    Join Date
    May 2013
    Location
    Россия
    Posts
    1
    Quote Originally Posted by spike View Post
    If bearing installed right put flashlight in cam journal and light should be seen in hole in main bearing web directly above it. easy check to see if holes align, block upside down
    Goops
    Looks like effective way to do it. Even I will use flashlight and try to implement your process. Thanks :)
    Last edited by TyroneAndrews; 05-26-2013 at 03:53 PM.

  3. #23
    Helpfull BT forum member Swabie
    Join Date
    Jan 2013
    Location
    NorCal
    Posts
    49
    New bearing was installed the way it was before...I primed the engine with oil...it definitely gets a ton through pushrods and cam gear. I don't think I'll have any oiling issues.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Bulltear Ad