Where is the procedure for re-doing the truck on the Y axis on the gantry? I can move this axis a little while everything is turned on. The mag mount does not move. So this is my next step I believe to alleviate some wavy corners. Also, if this does not fix my corners, should I try lowering my Accel and/or Velocity numbers?

Will 1 or 2 edges always have a slight bevel? ie never get 4 perfectly square edges on a square piece?

Best way to figure out kerf width is just straight lines, at varying cut speeds, until I get the smallest cut size? Using feeler guages? Top or bottom of cut, or should it be relatively the same on both sides?

Also, should I be checking Kerf Width on all material I cut? As in, 1/8, 3/16, 1/4 may actually all be different kerf widths for my setup?

Thanks for the continued support.