Decided to go with a chassi car . it is a older car that I had to update but here is where I am at now
should be a lot different then the small tire car
cut 2 inches out of the scoop, new sheet metal inside , replaced rear wheel openings , installed factory dash ,removed wing and installed spoiler
fender exit headers
Brewer heads..nice
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
Nice. I've been half-heartedly watching for a rusty AMX body that I wouldn't feel bad doing a back-half on for my next project. That's what I'd want it to look like.
Bob
tufcj
1969 AMX
1967 Rambler Rogue
If you need a tool and don't buy it...
you'll eventually pay for it...
and not have it.
Henry Ford
I bought this one out of Hotchkiss Co.
this one is a full tube chassi car that used to belong to Barry Allen.
Still have lots of fit and finish thing to do but It is a work in progress
Might have gotten a little loose
have a little wall rash on the left rear but all in all I got lucky
Wow ...yes! And that AMX looks awesome!
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
Yeah, that AMX looks amazing. Do you still gave it?
Okay so I figured out I am not smart enough to get the Mechanical Injection to work in my application.
So I converted it over to EFI.
First time out with the EFI
1.30 60 ft
9.17 @143
Very lean so needing to add more fuel just ran out of time
Car has run 152 mph so obviously down on HP.
Expecting to be in the 8's next time out.
Posting Permissions
Reply With Quote