I have been running the edelbrock 2132 cam in my 304 jeep.
The jeep has a t18a d/20 and sidetrack axles w/2.73 gears may swap to 4.10 gears in future
600cfm 1405, hei , stock exh manifolds . Mainly used on the street, does do some snow plowing and trail riding nothing serious.
It had a 2132 cam before engine rebuild 7-8years ago not many miles since . Does more sitting than anything .
Had a summit 8600 after rebuild and had went thru 3 sets or more of dizzy gears ( bad memories ) you can search the archives for story's . That's behind me since mc got me straighten out on dizzy . Thanks
Now I have a bad lifter again with the 2132 again 1st time I rebuilt engine because of it .
This time hopefully just cam and lifters.
Looking at the lunati voodoo 250/256 10100700lk
Or 256/262 10100701lk has anyone used these in a 304
Trying to get some advice any issues or problems is this a good vendor .
Will it be close to the 2132 performance
Looking for torque low don't go much over 5000 rpm .
But looking for the most off idle improvement .
The edelbrock was ok , just had bad luck .
It may have been the oil I was using 10w40 Mobil 1
And didn't use any zinc additive
I had noticed a ticking in the exh for a bit
Than was idling one day and started popping out carb - had a bent pushrod . Then found
A bad lifter on no. 3 hole .
Any advice on cams
There are so many out there and trying to educate my self .