-
Bulltear forum member
New to the forum
AMC 360 crank issues
I'm rebuilding this 360 and I'm at the point to install the crank and new bearings, The thrust plate bearing at the flywheel end is so tight it. I even put the old bearing in just to see if there was a different fit, it to is so tight the crank won't go into place. What am I doing wrong? This is my first build to so I'm on a learning curve
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules