Bulltear Ad
Results 1 to 2 of 2

Thread: DTHCIV ethercut motor/tuning settings with proton z?

  1. #1
    Bulltear forum member Cook
    Join Date
    Sep 2014
    Location
    Antarctica
    Posts
    12

    DTHCIV ethercut motor/tuning settings with proton z?

    Hey all I have a mach3 based system with the latest ethercut software/firmware but having trouble getting the THC dialed in. I find it often oscillates up and down unless I turn the tracking to 0 set the acc really low. What settings do you guys use? Is there something obvious that I could be doing wrong?

    Thanks in advance
    Jake

  2. #2
    Bulltear forum member Cook
    Join Date
    Sep 2014
    Location
    Antarctica
    Posts
    12
    I was hoping somebody could chime in with what settings they are using? I have it setup and working ok now but I am still having problems with the torch diving on corners and sometimes at the end of the cuts. I can get around it by using path rules in SC but that sometimes does things I don't expect. From what I understand the tip saver function should prevent these issues, what should I set it at?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Bulltear Ad