changing dana 20 yoke to cv style

[jeepsr4ever]

You can save big bucks doing this if you have a 10 spline shaft, 10 spline yoke! you can use the front yoke off a early quadratrack it had 10 spline and is identical, thats what i use on my 77' , i saved $180 ureal huh? for other spline counts and transfercases, the part can be ordered.

[jeepsr4ever]

i used the yoke from a 76 and earlier quadratrack (10spline) and i ran front driveshafts off FSJ's for my front and rear (cv style) if anyone is thinking about this swap let me know i can help find parts and i also make driveshafts

[78304CJ-7]

I am thinking of going CV stile on my jeep, currently Dana 20 with T-18 setup. Do you sugjest going CV front and back? Still need to put everything together so I better consider this before it is under the jeep!

[jeepsr4ever]

I absolutely suggest going to cv driveshafts front and back

[78304CJ-7]

ok, so. At the yard I need to look for a waggy with quadrtrac and yank the yokes on the BW T-case front and back and I should be good to go? Any years I should look for?

[jeepsr4ever]

if you have a 10 spline dana 20........that means early dana 20 74-and back the front yoke is the one you need other wise if your 20 case doesnt have the 10 spline it would be a custom order, my 20 case is a 67 in my 85 and i run the yokes off front quads 75 and earlier

[78304CJ-7]

Intresting.... ok. I have two Dana 20's. One that came on my 78 CJ-7, so I guess that will not be a 10 spline. However my T-18 that I got came from a 70 J series truck, I also have the Dana 20 that was mated to that so that should have the 10 spline correct?

Thanks MC!

[jeepsr4ever]

yeah pull that yoke and make sure, man i cant tell you what a difference a cv shaft makes!!!

[78304CJ-7]

I will check in a few. Going to go check those geers for you. Gotta find them though