but not sure if the tranny would hold up to the power of this engine..LOL
but not sure if the tranny would hold up to the power of this engine..LOL
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
I'm not sure what tranny to use, but I'd go with a NP-205 t-case at a minimum. Gear driven...should hold up
Hand me that hammer, I'll make it fit...
Not sure what it is you were asking about. The link for the picture is broken, and no photo is there. What is it you were inquiring about?
RamRods Northwest Chapter of AMO Member & Correspondent
International Scouts and Trucks of Oregon Event Coordinator, Member, & Correspondent
If memory serves me, the photo was one of a 747 jet engine, and MC (jeepr4ever) was wondering about installing it in a Jeep.
Hand me that hammer, I'll make it fit...