Dana 18 Input gear.

[78304CJ-7]

I need the input gear from a Dana 18 must be 29 teeth, 6 splines, with a 1.375” shaft. Anyone????

MC you gotta have one somewhere

-RJ

[jeepsr4ever]

i can get you a new one for just over cost in jan if you can wait till the middle of jan!

I dont have a case i want to tear apart or a bullgear

[78304CJ-7]

What kind of green we talking here..... I guess i acutally need some other gears as well.. I want to convert one of my D20 to the lower range I happened upon a Broco D20 so I am half way there. I guess I need some more gears I gott take the thing aprt to see what I have... I was looking at this :

http://www.jeeptech.com/convxfer/2.46-20/

and this:

http://www.off-road.com/~jweed/transfer.htm

Let me know...

-RJ

[fuzz401]

i have some old cases around would have to look and see what i have will look next week

[mrtazwrench]

I HAVE A CASE ON A 3SPD FROM A 74 CHEROKEE, WOULD IT HAVE ANYTHING YOU NEED?

[78304CJ-7]

Fuzz let me know.... there area few gears I need apparently.

mrtazwrench, I think that would be a D20... not sure though, is there a drum brake on the back of the T-case?

Does it look like this?






Easy way to tell, is the rear dif centered Cherokee..... I am pretty sure that will be a D20 already got two of them.

[Mudrat]

I guess I need some more gears I gott take the thing aprt to see what I have... I was looking at this :
http://www.jeeptech.com/convxfer/2.46-20/
and this:
http://www.off-road.com/~jweed/transfer.htm
Let me know...

-RJ

I like te "Almost painless" caveate

Mudrat

[78304CJ-7]

Yeah.... so far not too bad. I need two gears to compleate the conversion:


18 8 23
18 8 22

MC I know they can be had aftermarket let me know if you can get them and I will send some money your way. Good used ones work too

-RJ

[jeepsr4ever]

I will be able to get them cheap new in jan untill then you may find one of these guys have a used set..........but if you can wait i will order them for you in jan

[78304CJ-7]

MC sounds fine with me, I'm not in any huge rush to do this. When in Jan, like in a week or 5 weeks? Let me know as this has been a fun project and I look forward to working on it besides it is taking up valuable space on my bacement floor .

I need to get my 401 out and start working on it. Then I gotta get my NV4500 going.