This is a pic of the Torque Bar that I made for the Jeep... Don't bust on me too hard about the internal bracing... I know I should've angled/trianglated them...
All together this probably took about 3 to 3 1/2" hours to make... The milling went fast, (The set-up/break down took the longest)... The Chop-saw cut straight and fast... the welding probably took the second longest...



Let me know you people think..

Materials Used:
1 5/8" O.D. x 1/4" thick walled Tubing
1" O.D. x Either .187" or .200" thick walled tubing
1/4" Plate Steel
1/8" Plate Steel
7018 Welding Rods