Have an AMC 360 block at the NAPA Machine shop that has been tanked, magnafluxed and bored .030 over. Bad news - when I had a pile of scrap to be picked up the main caps were taken by mistake.

I do have another set from another engine and they are at the machine shop so line hone/bore can be checked.

It's been at the shop for a long time and I must get it out. Building an AMC 401 and I'd like to sell this.

Have $175.00 invested in this and I'd like to get that out of it.
Bath, NY 14810 - Can meet someone up to 100 miles with this early on a weekend.
If pictures are needed I can email.
hoppym38@yahoo.com