I'm taking my 1973 360 block i picked up in a waggy to the machine shop tomorrow.
Its going in my 76 CJ-7 in place of a tired 304

Have a few questions about what oiling mods need to be done.

The build will be pretty mild, Edelbrock intake, about 9 to 1 compression, crane H-260-2 cam, truck avenger carb, stock exhaust manifolds, dual exhaust

I was planning on ordering the increased pressure cam bearings, new timing cover with a midplate.

Is there any need to do any other mods that I need on an engine that will never see 5000 Rpm.

Any other things to watch out for.

I'm open to other suggestions before I get in too deep also.

Thanks for the help I'm new to AMC engines but this seems like the place to be to get help.