I bought a set of your cam/distributor gears recently. I just went to put the new distributor gear on and found the roll pin wouldn't go all the way through. After looking everything over, the hole in the distributor shaft is not centered - it's offset. The hole in the new gear is centered.

Have you ever heard of this before? At first I thought maybe the distributor was just drilled funny from the factory (OEM dist) but they wouldn't have drilled the gear and the shaft together, so that doesn't make sense. I'm probably going to order a new distributor ($50 at O'Reilly's) and maybe it will have a centered hole.

Any thoughts on a solution?

Thanks!