Quote Originally Posted by jeepsr4ever View Post
Sure it would read like G1 Y48. F30.

G1 is feed mode
Y48. is the length you want to cut (in Y axis from where you are..make sure you zero Y where you start)
F30. is feedrate 30 inches per minute (remember the period after 30 or it may default to .03 ipm) and also remember to fire your torch before pressing your enter key

These are entered at the MDI input line and are executed immediately after pressing enter.
This was definitely harder than I thought it would be. Setting the z axis to the right height was challenging; it was dragging the plate. Also... dont switch over to the machine window when cutting... it pauses the cut ><.

I think I may just make a sheetcam file for ripping sheets and just load it when needed.