I dabbled with this on an old flat fender. I didnt need have any problem with was rust.........its a non issue, the issue though is hydrogen burned much cooler and thus my running temps were lower.

The Electrolosis (spelling) required a DC voltage. the more surface area you can create of either copper plates or frayed copper bushes within the plastic/ glass tubes for the electrolosis to take place. by increasing that you can increase the rate which the water can be seperated. My uissue came with how i was metering it from the tubes into the Carburator, it tended to over fuel and i had the lack of knowledge to effectively create something to restict and contain excess gasses created.


I'll have to look back i was 16 when i played with that setup.