Like it says. I want to install a York compressor for OBA, but I can't find the correct crank pulley to make it work.
Anyone parting an older 360 that might have one?
Like it says. I want to install a York compressor for OBA, but I can't find the correct crank pulley to make it work.
Anyone parting an older 360 that might have one?
Can you run the York from a different pulley? I've installed a few and have used several different locations to drive the York. Even made one fit into the serpentine system on my 2000 XJ.
The 3 bolt engines used a single A/C belt that it shared with the PS (if it had it). It was also a wider belt than the alternator used. These only had a 2 groove crank pulley. I've never seen a 3 groove, 3 bolt pulley.
The later A/C used a dual belt, shared with the alternator. These had a 3 groove, 4 bolt bottom pulley.
You may need to change to a 4 bolt harmonic, along with the matching pulleys and water pump to make the later A/C work.
Bob
tufcj
1969 AMX
1967 Rambler Rogue
If you need a tool and don't buy it...
you'll eventually pay for it...
and not have it.
Henry Ford
If its 1974 or newer you can easily find the pullies. If its older we can make them but like it was mentioned you will need crank, water and alternator. 3 on the crank, 3 on the water and 2 on the alternator to get that AC to operate.
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689