Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958
Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958
Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958
Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2958 Gettin started - Page 8
HEre is the test procedures mine does this but flashes 3 times instead of 5.
Activate the recessed TEST Button on the front panel of the MP3000-DTHC or your unit with the DTHC module installed and connected. The TEST LED should start flashing.The unit goes into a test sequence where the TIP VOLTS DRO is set to 100 and the UP screen LED flashes 5 times. Then the TIP VOLTS DRO is set to 150 and the DOWN LED flashes 5 times. This test sequence repeats until you hit the Test Button again and the TEST LED stops flashing.
AIf the test does not show the above results the most probable cause is the serial communications is not working between the PC and the MP3000. Make sure you have the right port selected. If you were sent a special serial cable with the RS232 buffer module (see photo) make sure it is installed correctly.
WOW got her cuttin today! My first cut was with the THC on(brass nuckles) cut ipm was to slow (85 ipm) but the THC isnt dialed in so it was way out of wack. The second cut(alien head) i turned off the THC and cut at 110 imp and it did great hardly no dross. I used 1/8 material.
Last edited by wickedinhere; 09-07-2011 at 11:32 AM.
I just want space to put one!!! My shop is all wood and filled with a Jeep right now :-(
'Rat
" “It is said that men go mad in herds, and only come to their senses slowly, and one by one.." -Charles MacKay "'The trouble with our liberal friends is not that they're ignorant; it's just that they know so much that isn't so.' "
-Ronald Reagan VOTE
" “It is said that men go mad in herds, and only come to their senses slowly, and one by one.." -Charles MacKay "'The trouble with our liberal friends is not that they're ignorant; it's just that they know so much that isn't so.' "
-Ronald Reagan VOTE