Where do I adjust the delay before the thc takes over. I thought I knew but now I can't find it?
Where do I adjust the delay before the thc takes over. I thought I knew but now I can't find it?
Edit...we found a bug in the settings menu the THC delay actual may add to the peirce time. You best bet is under profile THC fault delay (did I say it right?) would be your THC delay.
Last edited by jeepsr4ever; 05-31-2012 at 12:45 AM.
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
Updated for you.
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
Where do i get the updated file for the bugfix?
Thanks
Borst
Last edited by BorstMetalWorks; 05-30-2012 at 11:51 AM.
No file change only an update to the post above. Please re-read post #2 the reply to the initial post.
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
This freezes THC until your in the cut and not in the pierce.
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
If you look on your support disk under DTHCII manual you will see where the DTHC delay setting is. This will allow you precise timing on your DTHC. If you experiencing plunges into the material your DTHC is turning on too fast. To counter this the high end systems have a delay. The system we use allows you to set the delay for accuracy. If you look in your "Cut profile" you will see it. The systems go out with presets for your "cut profile" for use with Hypertherm cutters however they will work with virtually any plasma.
[COLOR=#000000]
Featuring www.StarLabCNC.com[/URL] for CNC plasma machines
1-651-433-3689 TOLL FREE 1-855-433-3689
Thanks Matt!
I think in the cut profile it is called THC fault Delay. This is where we adjust the delay before the THC starts?