Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2968 Torch trying to fire on startup - Page 2
Well, I pulled the board out of my control box and sent it in to Candcnc for repair. They repaired it, and it supposedly showed up at my parcel brokerage yesterday, so I still need to go pick it up. It was tempting to upgrade to the new DTHC, but just couldn't justify it right now, especially with the table being down for the last month not bringing in any money. Really hope this fixes the problem.
pretty sure the yellow wire goes to the #1 pin, however I'm not about to hook it up without knowing for sure. I've tried looking through the schematics that were loaded onto my pc that I got with the table, but none of them are the same as mine.