-
Helpfull BT forum member
Admiral of the Forum
I just have to say that the CNC Plasma table is the best piece of equipment I have purchased as of yet. I have been able to think up some ideas, draw them up and then cut them out. So far to date I have made a shooting tree, silhouette target, and a couple of large wrenches for working on my skid steer. I'm going to try some art work next. There isn't a way I could have cut these projects out with a hand torch and retained the quality the way the CNC torch does, not even close. What a great machine,
Thanks Matt
Gary Gehrig
N4865 wellington lake drive
Medford, Wisconsin. 54451
Last edited by ggeh; 07-26-2017 at 08:02 AM.
-
Bulltear forum member
Swabie
-
Bulltear forum member
New to the forum
This is right after leveling, before I got it all dirty.
-
Helpfull BT forum member
Admiral of the Forum
Thanks for the free upgrade gussets and free shipping. mine came yesterday.
Thanks again, Gary
-
Bulltear forum member
New to the forum
Here's my table. My address is the same as on file. Let me know if you want me to email it to you.
Everyone's tables are so clean compared to mine. I feel like a bad owner!
-
Bulltear forum member
New to the forum
Grays customs
14188 Warren dr.
Grass valley CA 95949
-
Bulltear forum member
New to the forum
Grays customs
14188 Warren dr.
Grass valley CA 95949
-
Bulltear forum member
New to the forum
2014 Star Lab Gantry Kit
72" x 144" cut capacity
PM 85 primary and PM 65 secondary
-
Bulltear forum member
New to the forum
Been using daily for over three years down in Tasmania and it never misses a beat.( Not counting my half pallet of “oh shit I forgot to !” I creat every year )
Wish the post was cheaper so I could have another and not have to change over for routing.
-
Bulltear forum member
Cook
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules