The plan is to take the drivetrain from my 77 Cherokee (360/T18a/D20/D44's) and put them into a CJ (7 or 8) or a YJ. Tire size will be in the 36-38 range (MC if you have some D60's setup already let me know). The rear on the cherokee is already SOA and I want to do the front SOA with either RE SOA Springs or Rancho 44044's. What concerns will I run into with the suspension, will I have to get a Full Width Axle Kit? and if so why are they all SRS instead of standard. The D44 also has the flat top knuckles so I will be doing a high steer setup. I also know that the D44 front pumpkin is right close to the spring perch and welding steel/cast is difficult... give me some pointers fellas I want everything to go as smoothly as possible when I start putting it all together. Also if anyone has done the Trial and Error on the motor mounts to find the right place, can I get measurements to get it right the first time.